JJ TRAILER HAS THE RIGHT TO UPDATE AND CHANGE PRICES WITH OR WITHOUT NOTICE – PRICES MAY CHANGE AT TIME OF ORDER DUE TO EXCHANGE RATES, SUPPLIER PRICES INCREASE,..ETC. - AVAILABILITY SUBJECT TO PRIOR SALES

Errors and Omissions: Every effort has been made to ensure that the information given in this WEBSITE is correct at the time of publishing. However, due to continuous product improvement, prices changes, exchange rates, J & J Trailers Manufacturers and Sales Inc. reserves the right to make any changes to products and technical data without prior notice. The information listed within this website is to be used only for illustration purpose only. J & J Trailers Manufacturers and Sales Inc. is not liable in anyway or form for any errors or omissions, changes made before or after publishing or any misinterpretation of the data contained within this website.

Product Name WINCH WELD ON FOR UP TO 4" STRAPS
SKU 108-1820
Description

Weld-on winches are designed to be permanently mounted in a fixed position.

Specifications: A: 7.75" B: 4.88" C: 6.50" D: 3.54"

Working Load Limit: 5,500 lbs./2500 kgs.

Weight: 8.8 lbs., 4.0 kgs.

Warnings

Specification

Winches & Winch/Combination Bars

WARNING: When tightening or loosening winches, always maintain a firm grip on the winch bar. Never release a winch bar without checking the pawl to ensure that it is fully engaged between ratchet teeth. Releasing a winch bar without the pawl being properly engaged can cause serious injury to the user or bystanders. The use of a slip resistant handle winch bar, specifically designed to tighten or loosen winches, is recommended. Kinedyne winch bars (page 9) shall be used to tension and release tie-down assemblies. “Cheater Bars” (“extenders”) shall not be used with the winch bars. User shall stand clear of the winch bar handle during operation of the winch bar in case the winch bar slips. The tip of the winch bar shall be inserted through both holes in the end cap to prevent the winch bar from “slipping out” and overloading the tip and/or end cap. Winches shall not be loaded in excess of their working load limit. Winches shall not be used as pulling or lifting devices. A minimum of 12” of webbing shall be inserted through the slot, and a minimum of two (2) wraps shall be on the winch mandrel.

CAUTION: Excessive wraps of webbing on the mandrel will reduce the working load limit of the winch.

PORTABLE WINCH WARNING: Set screws on portable winches are designed to position the winch while the tie-down assembly is being tightened. They shall only be snug tight. Overtightening of screws may cause the bracket to bend, weakening the winch and causing it to fail. Portable winches shall be removed and stored when not in use.

Customer Reviews


Rating ReviewDate Title EntryHtml ParentReviewEntry Published VerifiedPurchase Email

North York Location is Temporarily closed due to constructions and renovations, please contact Scarborough location for any inquiries . We sincerely apologize for any inconvenience.